FHP Electromagnetic Brake Motors

FHP Electromagnetic Brake Motor or Fractional Horse Power EM Brake Motor is a combination of FHP Induction Motor fitted with electromagnetic fail safe brake (power off activated). These brake motors have minimum overrun of rotor and load holding capacity, after the electric supply is switched off. FHP single phase EM Brake Motor requires capacitor to start and run while three phase Brake Motor does not require a capacitor.

The typical no load speed of the ac fhp em brake motor at 50Hz supply is 2880 RPM for two pole winding, 1440 RPM for 4 pole winding, 960 RPM for 6 pole winding, 720 RPM for 8 pole winding and so on. By attaching a gearbox of desired ratio, it becomes low RPM Gearmotor.

Depending upon requirement for the connection, EM Brake Motor has lead wires or Terminal Box.

Suitable for continuous operation, frequent start stop, minimum overrun and load holding.

  • Square Frame sizes 80 mm, 90 mm
  • Output powers 25 watt, 60 watt, 90 watt, 180 watt
  • Rated Torque from 0.18 N.m to 20 N.m
  • Inline EM Brake Gear Motor with keyway type shaft and Motor with D type Round Shaft